Table of Contents
Advertisement
Understanding the printer menus
Use
Paper Saver Border
None
Solid
Staple Job
Auto
Back
Dual
Front
Off
Run Stapler Test
Hole Punch
On
Off
Hole Punch Mode
2 holes
3 holes
4 holes
Offset Pages
None
Between Copies
Between Jobs
Quality menu
Use
Print Resolution
300 dpi
600 dpi
1200 dpi
1200 Image Q
2400 Image Q
To
Print a border when using Paper Saver.
Note: None is the factory default setting.
Specify whether printed output is stapled.
Notes:
•
Off is the factory default setting.
•
This menu appears only when a supported staple finisher is installed.
Print a report that confirms that the staple finisher is functioning properly.
Note: This menu appears only when a supported staple finisher is installed.
Specify whether holes are created on printed outputs for the purpose of collecting
the sheets in a binder or folder.
Notes:
•
Off is the factory default setting.
•
This menu appears only when a supported staple, hole punch finisher is
installed.
Specify the number of holes to be created on printed outputs for the purpose of
collecting the sheets in a binder or folder.
Note: This menu appears only when a supported staple, hole punch finisher is
installed.
Offset pages at certain instances.
Notes:
•
None is the factory default setting.
•
Between Copies inserts a blank sheet between each copy of a print job if
Collate is set to (1,2,3) (1,2,3). If Collate is set to (1,1,1) (2,2,2), then a blank
page is inserted between each set of printed pages, such as after all page 1's
and after all page 2's.
•
Between Jobs sets the same offset position for the entire print job regardless
of the number of copies printed.
•
This menu appears only when a supported staple finisher is installed.
To
Specify the printed output resolution in dots per inch.
Note: 600 dpi is the factory default setting.
112
Advertisement
Table of Contents
