Indoor Unit
1.4
Removal of the Signal Receiver Unit / Swing Motor
Procedure
Step
1. Remove the signal
receiver unit.
1
Disengage the two
hooks (left and right
sides) to remove the
signal receiver unit.
2
Remove the wire
harness of the signal
receiver from the
groove.
2. Remove the swing motor.
1
Remove the two screws
holding the swing motor
in place.
120
Warning
Be sure to wait 10 minutes or more after turning off all power supplies
before disassembling work.
Procedure
Signal receiver unit
Swing motor
Points
(R2995)
Note:
Rearrange the wire harness in
position as it was when
reassembling signal receiver
unit.
(R2998)
Removal Procedure
SiBE05-311