Genie GS-1530 Operator's Manual page 32

Operator's Manual
Inspections
Test the Outrigger System
44 Press the lift function select button.
45 Press and hold the function enable switch on
the control handle.
46 Slowly move the control handle in the direction
indicated by the blue arrow.
Result: The platform should raise to
6.7 m and stop. The lift error indicator light will
turn red.
47 Fully lower the platform.
48 Press and hold the outrigger extend
button.
Result: The outriggers should not extend.
49 Press and hold the function enable
button. Press and hold the outrigger
extend button.
Result: The outriggers should extend. The
individual outrigger LED indicator lights will turn
green as the corresponding outrigger makes
contact with the ground.
Continue pressing the function enable and the
outrigger extend buttons until the lift enable
indicator light turns green and a beep is heard. The
machine is now level. At this point, the drive and
steer functions are disabled.
30
50 Press and hold the function enable switch on
the control handle.
51 Slowly move the control handle in the direction
indicated by the blue arrow.
Result: The platform should raise to
9.8 m and stop.
52 Fully lower the platform.
53 Press and hold the outrigger retract
button.
Result: The outriggers should not retract.
54 Press and hold the function enable button.
Press and hold the outrigger retract button.
Result: The outriggers should start retracting.
Release the function enable and the outrigger
retract buttons once the outriggers are off the
ground. After approximately 5 seconds, the
outrigger indicator lights will turn off. All functions
are now restored.
Note: The machine drive speeds are reduced the
first time the drive function is enabled after
retracting the outriggers. The drive speeds are
restored to normal after driving for approximately 6
seconds.
GS-30 • GS-32 • GS-46
Sixth Edition • First Printing
Part No. 227286