Genie GS-1530 Operator's Manual page 30

Operator's Manual
Inspections
Test Drive and Braking
27 Press and hold the function enable switch.
28 Slowly move the control handle in the direction
indicated by the blue arrow on the control panel
until the machine begins to move, then return
the handle to the center position.
Result: The machine should move in the
direction that the blue arrow points on the
control panel, then come to an abrupt stop.
29 Slowly move the control handle in the direction
indicated by the yellow arrow on the control
panel until the machine begins to move, then
return the handle to the center position.
Result: The machine should move in the
direction that the yellow arrow points on the
control panel, then come to an abrupt stop.
Note: The brakes must be able to hold the machine
on any slope it is able to climb.
28
Test the Tilt Sensor Operation
Note: Perform this test from the ground with the
platform controller. Do not stand in the platform.
30 Fully lower the platform.
31 Place a 2x4 or similar piece of wood under both
wheels on one side and drive the machine up
onto them.
32 Raise the platform approximately 2.1 m from
the ground.
Result: The platform should stop elevating and
the tilt alarm will sound at 600 beeps per
minute.
33 Move the drive control handle in the direction
indicated by the blue arrow, then move the
drive control handle in the direction indicated by
the yellow arrow.
Result: The drive function should not work in
either direction.
34 Lower the platform and remove both pieces of
wood.
GS-30 • GS-32 • GS-46
Sixth Edition • First Printing
Part No. 227286