Genie GS-1530 Operator's Manual page 15

Sixth Edition • First Printing
If equipped with outriggers
Do not set the machine up where it cannot be
leveled using only the outriggers.
Do not adjust the outriggers while the platform is
raised.
Do not drive while the outriggers are lowered.
Crushing Hazard
Keep hands and limbs out of scissors.
Keep hands clear when folding rails.
Do not work under the platform or in the scissor
links without the safety arm in place.
Use common sense and planning when operating
the machine with the controller from the ground.
Maintain safe distances between the operator, the
machine and fixed objects.
Operation on Slopes Hazards
Do not drive the machine on a slope that exceeds
the slope and side slope rating of the machine.
Slope rating applies to machines in the stowed
position.
Maximum
slope rating
Model stowed position
GS-1530 30% (17°)
GS-1532 30% (17°)
GS-1930 25% (14°)
GS-1932 25% (14°)
GS-2032 30% (17°)
GS-2632 25% (14°)
GS-3232 25% (14°)
GS-2046 30% (17°)
GS-2646 30% (17°)
GS-3246 25% (14°)
Note: Slope rating is subject to ground conditions
and adequate traction.
Part No. 227286
The guard rail system provides fall protection. If
occupants of the platform are required to wear
personal fall protection equipment (PFPE) due to
job site or employer rules, PFPE and its use shall
be in accordance with the PFPE manufacturer's
instructions and applicable governmental
requirements. Use approved lanyard attachment
point provided.
Keep the platform floor clear of debris.
Attach the platform entry chain or close the entry
gate before operating.
Do not operate the machine unless the guard rails
are properly installed and the entry is secured for
operation.
Do not sit, stand or climb on the platform guard
rails. Maintain a firm footing on the platform floor
at all times.
Maximum
side slope rating
stowed position
30% (17°)
Do not climb down from the platform when raised.
30% (17°)
Do not enter or exit the platform unless the
25% (14°)
machine is in the stowed position.
25% (14°)
30% (17°)
25% (14°)
25% (14°)
30% (17°)
30% (17°)
Be aware of extended platform position when
moving the machine.
25% (14°)
The machine must be on a level surface or
secured before releasing the brakes.
GS-30 • GS-32 • GS-46
Work Area Safety
Fall Hazards
Collision Hazards
Be aware of limited sight
distance and blind spots
when driving or operating.
Operator's Manual
13