With Manual Tilt Option - Invacare Pronto M71 Jr. with SureStep Owner's Operator And Maintenance Manual

With Manual Tilt Option

NOTE: For this procedure, refer to FIGURE 12.3 on page 76.
Removing
1. Place the wheelchair in a well ventilated area where work can be performed without
risking damage to carpeting or floor covering.
2. Verify the joystick On/Off switch is in the Off position and disconnect joystick cable.
Refer to Disconnecting/Connecting the Joysticks on page 85.
3. Tilt the seat assembly backward. Refer to Operating the Manual Tilt Option on
page 32.
4. Remove the tilt release lever. Refer to Removing/Installing Tilt Release Lever from
Stroller Handle on page 54.
5. Remove the mounting screw, two washers and locknut that secure the tilt cylinder to
the bottom of the seat (Detail "A" of FIGURE 12.3).
6. Slowly tilt the seat all the way back.
7. Remove the four locknuts (two on each side) that mount the cylinder mounting
bracket to the frame.
8. Slide cylinder mounting bracket with the cylinder off the mounting screws and move
aside.
NOTE: It is not necessary to remove the four mounting screws.
NOTE: The tilt release lever is connected to the tilt cylinder via the tilt release cable.
9. If necessary, disconnect the drive lock-out.
NOTE: It may be necessary to cut the tie wraps on the drive lock-out cable.
10. Disconnect the front battery from the controller (RED connector).
11. Disconnect the rear battery from the front battery (GREY connectors).
12. Unlatch the battery tie-down strap (not shown).
13. Lift the rear battery out of the battery tray using the battery handle.
14. Slide front battery back and lift out of battery tray using the battery handle.
Installing
1. Position front battery in rear of battery tray and slide forward into position.
2. Position rear battery in rear of battery tray.
NOTE: Route the battery strap underneath the battery cables.
3. Latch the battery tie-down strap (not shown).
4. Connect the rear battery to the front battery (GREY connector).
5. Connect the front battery to the controller (RED connector).
6. Slide cylinder mounting bracket with the cylinder onto the four mounting screws.
Part No 1122147
75
Pronto
SECTION 12—BATTERIES
® ™
M71 Jr. with SureStep
®