Without Manual Tilt Option - Invacare Pronto M71 Jr. with SureStep Owner's Operator And Maintenance Manual

SECTION 12—BATTERIES

Without Manual Tilt Option

NOTE: For this procedure, refer to FIGURE 12.2.
Removing
1. Place the wheelchair in a well ventilated area where work can be performed without
risking damage to carpeting or floor covering.
2. Verify the joystick On/Off switch is in the Off position and disconnect joystick cable.
Refer to Disconnecting/Connecting the Joysticks on page 85.
3. Remove seat from base. Refer to Removing/Installing the Seat Assembly on page 45.
4. Disconnect the front battery from the controller (RED connector).
5. Disconnect the rear battery from the front battery (GREY connector).
6. Unlatch the battery tie-down strap (not shown).
7. Lift the rear battery out of the battery tray using the battery handle.
8. Slide front battery back and lift out of battery tray using the battery handle.
Installing
1. Verify the joystick On/Off switch is in
the Off position and disconnect joystick
cable (not shown).
2. Position front battery in rear of battery
tray and slide forward into position.
3. Position rear battery in rear of battery
tray.
NOTE: Route the battery strap underneath the
battery cables.
4. Latch the battery tie-down strap (not
shown).
5. Connect the rear battery to the front
battery (GREY connectors).
6. Connect the front battery to the
controller (RED connector).
7. Reinstall seat assembly. Refer to
Removing/Installing the Seat Assembly
on page 45.
8. Connect joystick cable. Refer to
Disconnecting/Connecting the
Joysticks on page 85.
® ™
Pronto M71 Jr. with SureStep
® 74
Connectors
Rear
Battery
Battery
Handles
Battery
Tray
NOTE: Seat not shown for clarity.
FIGURE 12.2 Removing/Installing Batteries
- Without Manual Tilt Option
GREY
Front
Battery
RED
Connector
Plug into
Controller
Front of
Wheelchair
Part No 1122147