Removing/Installing/Adjusting Headrest; Removing; Installing - Invacare Pronto M71 Jr. with SureStep Owner's Operator And Maintenance Manual

SECTION 7—SEAT

Removing/Installing/Adjusting Headrest

DO NOT remove the screw that holds the headrest in the offset fixture. Refer to
FIGURE 7.6.
NOTE: For these procedures, refer to FIGURE 7.6.

Removing

1. Loosen, but DO NOT remove, the headrest knob that secures the headrest to the
headrest mounting bracket.
2. Remove the quick-release pin.
3. Remove the headrest from the headrest mounting bracket.

Installing

1. Make sure headrest knob is loose.
2. Install the headrest until the headrest stop sits on the headrest mounting bracket.
3. Install the quick-release pin.
4. If necessary, adjust the height, depth or direction of the headrest. Refer to Adjusting
Headrest Height on page 53 or Adjusting Headrest Depth/Direction on page 53.
Slide Tube
DO NOT remove
this screw.
Offset Fixture
Socket Screws
Set Screw
Headrest
Stop
Spreader Bar on
Wheelchair
Quick-
Release Pin
Headrest Mounting
Bracket
FIGURE 7.6 Removing/Installing/Adjusting Headrest
® ™
Pronto M71 Jr. with SureStep
WARNING
Depth Adjustment
Headrest
Height
Adjustment
Headrest
Knob
® 52
Quick-Release
Pin Installed
DETAIL "A"
Left to
Right
Adjustment
Headrest
Side to Side
Adjustment
Up and Down
Adjustment
Part No 1122147