Adjusting Headrest Height; Adjusting Headrest Depth/Direction - Invacare Pronto M71 Jr. with SureStep Owner's Operator And Maintenance Manual

Adjusting Headrest Height

1. Loosen the set screw on the headrest stop.
2. Loosen, but DO NOT remove, the headrest knob that secures the headrest to the
headrest mounting bracket.
3. Remove the quick-release pin.
4. Position the headrest to the desired height.
5. Tighten the headrest knob to secures the headrest to the headrest mounting bracket.
6. Install the quick-release pin.
7. Tighten the set screw on the headrest stop.
8. If necessary, adjust the depth or direction of the headrest. Refer to Adjusting Headrest
Depth/Direction on page 53.

Adjusting Headrest Depth/Direction

Do not remove the screw that holds the headrest in the offset fixture. Refer to
FIGURE 7.6.
1. Loosen, but DO NOT remove, the three socket screws that secure the offset fixture to
the slide tube.
2. If necessary, reposition the headrest to the desired depth by sliding the headrest
towards the front of the wheelchair or towards the rear of the wheelchair.
3. If necessary, reposition the headrest to the desired position (headrest will move in any
direction). Refer to Detail "A" in FIGURE 7.6.
4. While holding the headrest in the desired position, securely tighten the three socket
screws.
5. If necessary, adjust the height of the headrest. Refer to Adjusting Headrest Height on
page 53.
Part No 1122147
WARNING
53
SECTION 7—SEAT
® ™
Pronto M71 Jr. with SureStep
®