Table of Contents
Advertisement
DANGER!
Risk of Death or Serious Injury
Not wearing your seat positioning strap could result in
death or serious injury.
– ALWAYS wear your seat positioning strap. Your
seat positioning strap helps reduce the possibility
of a fall from the wheelchair. The seat positioning
strap is a positioning belt only. It is not designed for
use as a safety device withstanding high stress loads
such as auto or aircraft safety belts. If signs of wear
appear, seat positioning strap MUST be replaced
IMMEDIATELY.
7.31.1 Wheelchairs without TRRO Option
1.
Remove the seat cushion from the seat pan.
2.
Rotate the flip back armrests up, out of the way. Refer to 6.6
Positioning Flip Back Armrests, page 30.
Remove the two mounting screws A, washer B, and locknuts C
3.
that secure the quick-release pins D and seat positioning straps
E to the seat frame F.
4.
Remove the seat positioning straps.
5.
Install the two new seat positioning straps inside of the seat
frame as shown.
6.
Secure the seat positioning strap and quick-release pin to the
seat frame with the two mounting screws, washers, and locknuts.
Torque to 75 in-lbs.
7.
Reinstall the seat cushion onto the seat pan.
8.
Lower the flip back armrests down, back into position. Refer to
6.6 Positioning Flip Back Armrests, page 30.
7.31.2 Wheelchairs with TRRO Option
To replace the seat positioning strap, refer to the wheelchair base
user manual supplied with the wheelchair.
1143192-L-03
7.32 Removing/Installing/Adjusting Headrest
WARNING!
– If using a ventilator, verify headrest support does not
interfere at all angles. Otherwise, injury or damage
may occur.
7.32.1 Removing the Headrest
Loosen, but DO NOT remove, the thumb screw A that secures
1.
the headrest mounting tube B to the headrest mounting bracket
C.
2.
Remove the headrest mounting tube from the headrest mounting
bracket.
Setup Maintenance
53
Advertisement
Table of Contents
