Removing The Side Frame Assemblies - Invacare Pronto M71 Jr. with SureStep Owner's Operator And Maintenance Manual

Right Side
Assembly
Seat Frame
Attachment Points
(On Both Sides)
NOTE: Battery tie-down strap not shown.
*NOTE: Front and rear shrouds are removable but removing the shrouds is not
required for transporting.

Removing the Side Frame Assemblies

10. Using your left hand, grip the left side frame at the large cutout in the side shroud.
11. Using your right hand, lift up on the frame release lever at the front of the battery
section on the left side (Left Side Frame Label #1).
12. While the frame release lever is activated, separate the upper front clevis pin (Left Side
Frame Label #1) and upper rear clevis pin (Left Side Frame Label #2) away from the
battery section while simultaneously lifting the frame release lever and battery
section.
13. Continue lifting the battery section with the right hand until the battery section lifts
completely away from the lower clevis of the left side frame (Left Side Frame Label
#3).
14. Slide the left side frame away from the battery section and lay down on it's side or
leave in an upright position by turning both the front and rear caster inward.
15. Repeat STEPS 9 to 13 for the opposite side frame assembly.
Part No 1122147
SECTION 14—TRANSPORTING THE WHEELCHAIR
Seat
*Rear
Shroud
Battery Tray
FIGURE 14.1 Disassembling the Wheelchair
Batteries
Attachment Points
Front Frame
Footrest
Support. Release
handle is located
underneath.
89
Pronto
Side Frame
(On Both Sides)
Left Side
Assembly
*Front Shroud
® ™
M71 Jr. with SureStep
®