Lubricate The Driveshafts; Perform Engine Maintenance - John Deere Models - Genie GTH-636 Service Manual

June 2007
REV B
B-9

Lubricate the Driveshafts

Note: Genie requires that this procedure be
performed every 250 hours or quarterly, whichever
comes first.
Greasing the specified locations is essential for
good machine performance and service life.
Operating the machine with little or no grease
may cause the machine to perform poorly and
continued use may cause component damage.
1 Using a grease gun, thoroughly grease the
driveshafts at each of the locations indicated in
the illustration.
Grease Specification
Chevron Ultra-duty grease, EP NLGI 2 (lithium based)
or equivalent
b b
a rear driveshaft
b front driveshaft
Part No. 97487 GTH-636 • GTH-644 • GTH-842 • GTH-844 • GTH-1048 • GTH-1056
b a a a
Section 3 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
B-10
Perform Engine Maintenance -
John Deere Models
Note: Engine specifications require that this
procedure be performed every 250 hours of
operation.
Required maintenance procedures and additional
engine information is available in the
John Deere 4045T270 Operator's Manual
(John Deere part number OMRG25204) OR the
John Deere 4045T275 Operator's Manual
(John Deere part number OMRG33324).
John Deere 4045T270 Operator's Manual
Genie part number
John Deere 4045T275 Operator's Manual
Genie part number
97492
108444
3 - 23