Genie GTH-636 Service Manual page 105

June 2007
REV B
How to Remove the 4-way
Controller (joystick)
1 Locate and open the battery access door.
2 Disconnect the battery from the machine.
Electrocution hazard. Contact with
electrically charged circuits could
result in death or serious injury.
Remove all rings, watches and
other jewelry.
3 Remove the fasteners securing the 4-way
controller (joystick) access cover to the side
console. Set the cover to the side.
4 Tag, disconnect and plug the hoses from ports
1, 2, 3, 4, P and T of the joystick. Cap the
fittings.
5 Tag and disconnect all three red wires and the
grey wire from the tilt relay.
6 Remove the fasteners securing the joystick to
the side console.
7 Remove the joystick from the side console.
Part No. 97487 GTH-636 • GTH-644 • GTH-842 • GTH-844 • GTH-1048 • GTH-1056
Section 4 • Repair Procedures
OPERATOR'S COMPARTMENT
How to Remove the Accelerator
Pedal
1 Locate and open the battery access door.
2 Disconnect the battery from the machine.
Electrocution hazard. Contact with
electrically charged circuits could
result in death or serious injury.
Remove all rings, watches and
other jewelry.
3 Remove the fasteners securing the pedal
assembly to the floor.
4 Carefully lift the pedal assembly and place in a
secure position to allow access the underside
of the accelerator pedal.
5 GTH-1048 and GTH-1056: Tag and disconnect
the Deutsch connector from accelerator pedal.
All other models: Tag and disconnect the
throttle cable from accelerator pedal.
6 Remove the fasteners securing the accelerator
pedal in place.
7 Set the fasteners aside and remove the
accelerator pedal.
4 - 35