Parts Identification - SATO DR308e Operator's Manual

1.2 PARTS IDENTIFICATION

1 Main Cover
2 Display panel
3 STATUS (LED) indicator
4 LINE button
5 FEED button
6 Media ejection slot
7 Optional device
compartment
8 Cover for potentiometer
and Dip switch compart-
ment
Main cover
1
Open and close this cover to load the media
and ribbon.
Display panel
2
Displays an error and operation messages.
STATUS (LED)
3
Lights or flashes to indicate the printer status.
It turns red when error occurred, turns green
when printing and data communication are
enabled (ONLINE) and turns off when the
printer is in OFFLINE mode.
LINE button
4
Used to start or stop printing, and also to
toggle between the on/off settings for data
transmission and reception.
When the printer is in configuration setting
mode, it is pressed to select options or adjust
the settings.
DR308e Operator's Manual
Front View of DR308e
FEED button
5
Press once to feed one blank label.
When the printer is in configuration setting
mode, it is pressed to enters to the selected
mode.
Media ejection slot
6
Opening for media output.
Optional device compartment
7
This printer comes with a tear-off cover. An
optional device can be installed on this
compartment, e.g. dispenser, cutter, stacker or
external rewinding unit.
Cover for potentiometers and Dip switch
8
compartment
Open the cover to access the potentiometers
and Dip switch for adjustment.
Section 1: Introduction
Page 1-3