SATO DR308e Operator's Manual page 42

Section 3: Operation and Configuration
3.8 ADVANCE MODE (cont'd)
3.8.5 Setting the Print Method Mode
The printer can be switched to operate in Thermal Transfer or Direct
Thermal mode with this setting.
1.
When PRINT METHOD is displayed, press FEED button to enter to the
setting mode.
2.
Press the LINE button to select the TRANSFE (Thermal Transfer) or
DIRECT (Direct Transfer) option.
The default value is TRANSFE.
3.
Press the FEED button to confirm your selection and proceed to the next
setting.
3.8.6 Configuring the Pitch Sensor
The printer can be switched to operate the Pitch Sensor in Enable or
Disable mode. This option is not available when using dispenser or tear-
off unit.
1.
When PITCH SENSOR is displayed, press FEED button to enter to the
setting mode.
2.
Press the LINE button to select the ENABLE or DISABLE option.
The default value is ENABLE.
3.
Press the FEED button to confirm your selection and proceed to the
next setting.
NOTE:
When changing from ENABLE to DISABLE, setting the PRINT MODE to
CUTTER and BACKFEED MOTION is AFTER2, change backfeed motion
to NONE.
3.8.7 Setting the Head Check Mode
The printer can be set to perform a check of the print head when printing
each label.
1.
When HEAD CHECK is displayed, press FEED button to enter to the
setting mode.
2.
Press the LINE button to select the ENABLE or DISABLE option.
The default value is DISABLE.
3.
Press the FEED button to confirm your selection and proceed to the
next setting.
3.8.8 Choosing the Type of Head Check
If Head Check has been ENABLE, you can specify the print head
checking to be performed unconditionally, or only when barcodes are
being printed.
1.
Press the LINE button to select the NORMAL or BARCODE option.
The default option is NORMAL.
2.
Press the FEED button to confirm your selection and proceed to the
next setting.
Page 3-18 DR308e Operator's Manual