Interface Mode - SATO DR308e Operator's Manual

3.7 INTERFACE MODE

In this mode, you can set various parameters governing the use of interface cards. Due to the wide range of
interface cards available, only the default interface configuration settings are covered in this section. The
menus in the INTERFACE SET mode will be specific to type of interface card used. A flowchart overview of
advanced settings for all the optional interface cards is as shown in the following. Please refer to an
authorised service personnel for a detailed discussion on this advanced settings.
Overview of Interface Mode configurations
1
OFFLINE mode
When INTERFACE MODE is displayed, press the FEED button to enter to Interface mode for adjustment.
Note:
PASSWORD may prompt on the display if password input is enabled. Please refer to Sato certified servic-
ing personnel for details in password inputting.
DR308e Operator's Manual
FEED
Password menu displayed
only when the password input
is enabled.
FEED
FEED
LINE
LAN
setting
FEED
LINE
FEED
LINE
Section 3: Operation and Configuration
IEEE 1284
setting
The Interface setting option display
according to interface board installed.
FEED
There is no setting option when using
USB interface board.
FEED
When STATUS4
Other than
is selected
STATUS4
is selected
1
Return to OFFLINE mode.
Press FEED button while pressing
LINE button to return to previous
display.
Optional route.
RS-232C
setting
FEED
Page 3-11