Loading Labels Or Tags - SATO DR308e Operator's Manual

Hide thumbs Also See for DR308e:

Table of Contents

2.2 MEDIA SELECTION (cont'd)

This printer accepts two types of media core sizes, φ 40mm (1.5in.) and φ100mm (4in.). When using φ100mm

(4in.) core size media, the supplied core adaptor and guide plates need to be installed to the printer. Please

refer to Section 2.3.2 Loading Roll media with a large media core on page 2-5 for further instructions.

2.3 LOADING LABELS OR TAGS

2.3.1 Loading Roll media with small media core

With the power supply is off, lift up the main cover.

Make sure that the cover rests firmly so that it will not fall

forward and injure your hands.

Remove the roll media guide by pressing the release

tab with your thumb and index finger and pulling it out.

Load the media to the roll media supply spindle.

Make sure the media leader is pull out from the bottom

and the printed side is facing upwards. Push the roll

firmly towards the end of the spindle.

DR308e Operator's Manual

φ 40mm (1.5")

φ100mm (4")

Main cover

Printed

side

should

face

upwards

Section 2: Installation

Page 2-3

Table of Contents