Stacker; Cut Position Adjustment; Cutter Replacement - SATO DR308e Operator's Manual

Hide thumbs Also See for DR308e:

Table of Contents

Section 8: Optional Accessories

8.1 CUTTER (cont'd)

The cutting position can be adjusted with the OFFSET potentiometer. Refer to Section 3.6.1 Offset Volume

mode on page 3-8.

Notes:

•

Cutting of Labels

The correct cutting position is at the label gap. Cutting

onto the label must be avoided because the glue that

accumulates on the blade will affect cutter sharpness.

•

Cutting Media with Perforation

As for media with perforation, +/- 1mm (+/- 0.04 in.) from

perforation is the non-cut area. Adjust the OFFSET

potentiometer to obtain correct cut position.

Replace cutter unit when blade becomes blunt and cut

edges are rough. (Please contact the sales outlet where

you purchase the DR308e.)

8.2 STACKER

Stacker is to be installed onto the cutter cover. With the stacker unit installed, the cut tags are collected and

stack up neatly.

Set the stacker in front of the printer and hook it onto the

cover of the cutter compartment as shown.

Page 8-2

Cut Position

+/- 1mm

DR308e Operator's Manual

Label

Backing paper

Label

Perforation

Table of Contents