System Events; Panel Status; System Trouble - Bosch Solution 144 User Manual

Solution 144 User Guide

System Events

Options in this section relate to programming of system
wide options and interpretation of system trouble events
when and if they occur. Some events such as open zones
will appear as single events while others may be grouped
together. In this case you need to drill down to see the
specific detail for each event.
Your installer will advise you how to interrogate system
trouble events.
System > Commands >

Panel Status

The panel staus menu displays the panel software version
information as well as highlighting any system troubles that are
currently in effect. This is a view only location.
System > Commands >

System Trouble

The System Trouble Menu displays all current system
troubles in a list format. Some trouble events require you
to drill down to fully interpret while others such as an
unsealled zone can be interpreted at the top level. "Table
8: Control Panel Trouble Messages" on page 35 lists the
various trouble conditions that may be displayed and their
meanings
Enter programming mode (PIN + MENU) then,
1. Press [MENU] + [7] + [0] + [1].
The keypad will display a list of all current system
and non system trouble conditions.
To determine the system trouble condition,
highlight the panel number (P001 to P002) that you
want to view using the [] and [] keys, then press
[OK] to select.
System Trouble
Zn1 Zone 1 Name
Op3 Output Trouble
Press

To determine the non system (zone) trouble
condition, highlight the zone number Zn1 to Z016)
that you want to view using the [] and [] keys,
then press [OK] to select.
P001 System Trouble
Zn1 Zone 1 Name
Zn2 Zone 2 Name
Press

2. If viewing system trouble conditions, the keypad
will display similar to the following:
34
MENU 7-0-0
MENU 7-0-1
OK or MENU
OK or MENU
Panel 1
Solution 144 Ver 2.00
Date And Time
Press OK or MENU
The third line of the keypad display scrolls between
all current system trouble events.
If viewing non-system trouble conditions, the
keypad will display similar to the following:
Zone 1 Name Zn1
EOL=Open 55968 ohms
Press OK or MENU
3. Press [OK] or [MENU] to exit the system trouble
menu command:
If there are no system troubles, the keypad will
display:
There are no
system troubles.
Press

Refer to the Trouble Messages table for a complete
list of trouble events and their meanings.
Bosch Security Systems 04/12 BLCC600U
OK or MENU