Door Override; Output Name; Door Name - Bosch Solution 144 User Manual

Solution 144 User Guide
0000000001111111
1234567890123456
LLLLL---UUUUO---
Press

In the above example screen,
L = Doors 01 to 05 are Locked
O = Door 13 has a Override condition
U = Doors 09 to 12 area Unlocked
- = Doors 06 to 08 and Doors 14 to 16 are Disabled or
Not Available
2. When finished press [OK] or [MENU] to exit.
Outputs > Commands >

Door Override

This menu allows the master user to override the current
state of the selected door.
1. Enter [MENU] + [4] + [0] + [5].
A list of available doors will display on the keypad.
Dr1 Front Door
Dr2 Computer Room
Dr3 Warehouse Door
Press

2. Use the [] and [] keys to select the door that
you want to override, then press [OK] to select.
Alternatively, you can enter the door number then
press [OK].
The keypad will display the following:
Front Door Dr1
Door Locked
To Override, Press OFF
To Go Back Press OK
3. The following door states can be displayed in the
door status menu.
Door Locked
Door Unlocked
Unlocked by TimeZone
Locked by TimeZone
Overridden Unlocked
Overridden Locked
4. When finished press [OK] or [MENU] to exit.
26
OK or MENU
MENU 4-0-5
OK or MENU
Outputs > Properties >

Output Name

This menu allows you to program the name for each output.
Each output name supports up to 20 characters.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [1] + [0].
A list of available outputs will display on the keypad.
2. Use the [] and [] keys to select the output name
that you want to change, then press [OK] to select.
Alternatively, you can enter the output number,
then press [OK].
The keypad will display the following:
Output Name Op1
External Siren
Press

3. Use the [] and [] keys to scroll the cursor left and
right across the output name text. Use the [] and
[] keys to scroll through the different characters
available. To clear all text from the cursor position
to the right, press the [OFF] key.
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Outputs > Door Control >

Door Name

This menu allows you to program the name for each door
on the system. Each door name can be up to 20 characters
long.
Enter programming mode (PIN + MENU) then,
1. Enter [MENU] + [4] + [2] + [0].
A list of available doors will display on the keypad.
2. Use the [] and [] keys to select the door name
that you want to change, then press [OK] to select.
Alternatively, you can enter the door number, then
press [OK].
The keypad will display the following:
Door Name Dr3
Door 3 Name
Press

3. Use the [] and [] keys to scroll the cursor left and
right across the door name text. Use the [] and
[] keys to scroll through the different characters
available. To clear all text from the cursor position
to the right, press the [OFF] key.
4. Press [OK] to save and exit, or press [MENU] to exit
without saving.
Bosch Security Systems 04/12 BLCC600U
MENU 4-1-0
OK to SAVE
MENU 4-2-0
OK to SAVE