Table of Contents
Advertisement
NewLife
Elite Service Manual
®
5.7.2 Circuit Board Installation
5-9
Push in on the locking tab to the alarm 6-pin connector to
4
disconnect it.
5
With a slotted screwdriver, push in on the board support tabs,
while you lift each corner of the circuit board.
Remove the circuit board.
6
1
Push the circuit board on to the support tabs.
Firmly plug in the 6-pin connector to the circuit board so that
2
the connector's locking tab locks against the circuit board.
3
Plug in the 10-pin connector.
Reconnect the back and side panels.
4
NOTE
If a pressure transducer circuit board,
cut tie-wrap at circuit board and
disconnect green 1/4-inch tube. Plug/
cap open end of tube until new circuit
board is replaced.
NOTE
Handle the new circuit board only
by the edges to prevent electro static
damage to the unit.
NOTE
If a pressure transducer circuit board,
first reinstall 1/4-inch green tube with
new tie-wrap.
AirSep
Corporation
®
Hide quick links:
Advertisement
Table of Contents
