Ip Screen - ZyXEL Communications nwa1100-n User Manual

10.4 IP Screen

Use this screen to configure the IP address for your NWA. Click IP to display the following screen.
Figure 45 IP Setup
The following table describes the labels in this screen.
Table 23 IP Setup
LABEL
Obtain IP Address
Automatically
Use Fixed IP Address
IP Address
Subnet Mask
Gateway IP Address
Apply
Reset
NWA1100-N User's Guide
DESCRIPTION
Select this option if your NWA is using a dynamically assigned IP address from a
DHCP server each time.
Note: You must know the IP address assigned to the NWA (by the DHCP server) to
access the NWA again.
Note: If the NWA attempts but failes to get an IP address from the DHCP server three
times, the NWA then uses the default IP address (192.168.1.2).
Select this option if your NWA is using a static IP address. When you select this
option, fill in the fields below.
Enter the IP address of your NWA in dotted decimal notation.
Note: If you change the NWA's IP address, you must use the new IP address if you
want to access the web configurator again.
Type the subnet mask.
Type the IP address of the gateway. The gateway is an immediate neighbor of your
NWA that will forward the packet to the destination. On the LAN, the gateway must
be a router on the same segment as your NWA; over the WAN, the gateway must be
the IP address of one of the remote nodes.
Click Apply to save your changes.
Click Reset to begin configuring this screen afresh.
Chapter 10 IP Screen
91