Face Installation & Sizing - 36 Dv Face - Travis Industries 35 CB Australian Owner's Manual

14
Face Installation & Sizing - 36 DV Faces
Steps for installing 36 DV Faces
With the fireplace in place and glass removed, install the tile stop for the type of
a)
face used (see illustration to the right) - included with kit # 98500536.
Install the face mounting brackets (included with kit # 98500536).
b)
Install the tile (or other non-combustible facin). Make sure tile does not interfere
c)
with the press-nuts on back of the mounting brackets (see page 12).
Slide the mounting brackets all the way back against the facing.
d)
Install the face using the instructions included with the face, disregarding any
e)
bracket instructions. Refer to the illustration of the bracket (below right) to
determine the correct hole or slot for attaching the face to the brackets.
Classic Arched
(Gold, Black, or Artisan*)
5" (127 mm)
Radius = 35" (889 mm)
29"
(737 mm)
36" (914 mm)
* Artisan faces may vary slightly in size
due to the forging process.
Travis Industries
Installation
Arched Faces
Attach the center bracket through
the key-hole slots.
Tighten the nuts
on the bracket to
secure.
Left Side Face
Mounting Bracket
Rectangular Bevel Face
(Black or Gold)
Access Door
27-1/2" (699 mm)
(for qualified installers only)
(requires part # 98500536)
The tile stops
attach to
these holes
Detail of Mounting Bracket
These holes in the mounting brackets are
slotted to allow for different thicknesses of tile
1/4" Nutdriver
(or other non-combustible facing).
Right Side Face
Mounting Bracket
3/8" Wrench
Access Door
38"
(965 mm)
9 3 5 0 8 1 3 4
Tile Stop for
Arched Faces
Tile Stop for Rectangular
and Architectural Faces
Rectangular
Bevel Faces
Classic Arched
Faces (except
artisan)
Architectural
Faces
Artisan Faces
Architectural Faces
(French Country,
Arts & Crafts,
Art Deco, or Neo-Classical)
29-3/8"
(746 mm)
36-1/4"
(921 mm)
Access Door
4 0 3 0 6 2 4