Index - IBM 7012 G Series Service Manual

Index

A
acronym to FRU list, 7-1
adapter, device connection, 5-5
adapters, removal and replacement procedure,
4-14
antistatic bags, 4-2
AutoserviceIPL Flag, 2-36
B
base unit, hard disk, removal and replacement
procedure, 4-24
battery, removal and replacement procedure, 4-42
block, key, removal and replacement procedure,
4-49
Boot Multiuser AIX in Service Flag, 2-37
BUMPConsole Flag, 2-36
C
cable connection, scsi, expansion installation, 6-1
cable interconnection, rs-485, expansion
installation, 6-1
card, rs-485, removal and replacement procedure,
4-40
circuit breaker (CB), 5-3
cluster power control (CPC), 1-9
communications statements, vii
connectors, system planar locations, 1-10
CPC (cluster power control), 1-9
CPU card, removal and replacement procedure,
4-34
CPU card retainers, 4-22
CPU enclosure – minimum configuration, 3-1540-1
Customer Maintenance Password, 2-37
customer outlet, checking, 5-3
D
device connection
adapter, 5-5
standard I/O port, 5-4
device, attached, setting up, 5-4
Dial–OutAuthorization Flag, 2-36
digital multimeter, 5-3
dimension, 1-14
disconnection expansion units, 6-2
disk drive (base unit), removal and replacement
procedure, 4-24
diskette drive, removal and replacement procedure,
4-29
E
Electronic Mode Switch from Service Line Flag,
2-37
elm, system planar, removal and replacement
procedure, 4-46
error codes, off line diagnostics, D-1
error logging, PKSR register, D-26
expansion installation, 6-1
disconnecting expansion units, 6-2
recognizing the new unit, 6-1
rs-485 cable interconnection, 6-1
scsi cable connection, 6-1
F
fan, removal and replacement procedure, 4-19
FastIPL Flag, 2-36
flash EEPROM, reloading, B-7
front cover, removal and replacement procedure,
4-3
front fan, removal and replacement procedure,
4-20
X-3
Index