Communications Statements; United Kingdom Telecommunications Safety Requirements - IBM 7012 G Series Service Manual

Table of Contents

Communications Statements

The following statement applies to this product. The statement for other products intended

for use with this product appears in their accompanying manuals.

Federal Communications Commission (FCC) Statement

Note: This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference when the equipment is

operated in a commercial environment. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful

interference in which case the user will be required to correct the interference at his

own expense.

Properly shielded and grounded cables and connectors must be used in order to meet FCC

emission limits. Neither the provider nor the manufacturer are responsible for any radio or

television interference caused by using other than recommended cables and connectors or

by unauthorized changes or modifications to this equipment. Unauthorized changes or

modifications could void the user's authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired

operation.

This equipment is manufactured to the International Safety Standard EN60950 and as such

is approved in the UK under the General Approval Number NS/G/1234/J/100003 for indirect

connection to the public telecommunication network.

The network adapter interfaces housed within this equipment are approved separately, each

one having its own independent approval number. These interface adapters, supplied by the

manufacturer, do not use or contain excessive voltages. An excessive voltage is one which

exceeds 70.7 V peak ac or 120 V dc. They interface with this equipment using Safe Extra

Low Voltages only. In order to maintain the separate (independent) approval of the

manufacturer's adapters, it is essential that other optional cards, not supplied by the

manufacturer, do not use main voltages or any other excessive voltages. Seek advice from a

competent engineer before installing other adapters not supplied by the manufacturer.

International Electrotechnical Commission (IEC) Statement

This product has been designed and built to comply with IEC Standard 950.

vii

Preface

Table of Contents