Expansion Unit SCSI Cable
Removal
Note: Before removing the SCSI cable from the expansion unit, note how it is routed.
1. Remove the front cover, the side cover, and the rear cover of the unit following the
procedures described in "Front Cover" on page 4-3, "Side Cover" on page 4-6, and "Rear
Cover" on page 4-8.
2. Loosen the two screws shown in the figure to unlock the SCSI connector from the unit.
3. Disconnect the SCSI cable connectors from any hard disks, from any media device, and
from the ECB card.
4. Remove the bracket which holds the SCSI cable to the unit structure.
5. Remove the SCSI cable from the unit.
Removal and Replacement Procedures
4-51