Operating Procedure - Brother MFC-9130CW Service Manual

WSW No.
WSW73 Reserved (Change of the setting is prohibited)
WSW74 ADF stop control
WSW75 Paper ejecting distance of the switch back
WSW76 The limited number of the documents in reverse for paper ejection of the
one-sided scanning from ADF
WSW77 The limited number of the documents in reverse for paper ejection of the
two-sided from ADF
WSW78 Recording stop function when the drum reaches the end of life
WSW79 Function setting 27
WSW80 Copying speed control function
WSW81 Changing emulation function enable/disable setting
WSW82 AirPrint Icon No. setting
* For more information on the worker switch, refer to Reference.
<Operating procedure>
(1) Press the 1 and 0 keys in this order in the initial state of the maintenance mode.
"WSW00" is displayed on the LCD.
(2) Enter the number of worker switch to change.
The following is displayed on the LCD.
Selector 1
(3) Move the cursor to the selector you want to change with the < and > keys, and change the
value by pressing the 1 or 0 key.
(4) When you finish changing the value, press the SET key. This operation saves the newly
entered selector values onto the EEPROM and readies the machine for accepting a
worker switch number (WSW00).
(5) When worker switch setting is completed, press the Stop key to return the machine to the
initial state of the maintenance mode.
Memo:
- To cancel this operation and return the machine to the initial state of the maintenance
mode during the above procedure, press the Stop key.
- If there is a pause of more than one minute after a single-digit number is entered for
double-digit worker switch numbers, the machine will automatically return to the initial
state of the maintenance mode.
Selector 8
5-15
Function
Confidential