Brother MFC-9130CW Service Manual page 67

Error message
Upper line
Replace Open the Top
Toner Cover, replace
Toner Cartridge.
Replace WT Replace the Waste
Box Toner Box inside
the machine. To
get to it, remove all
the Drums &
Toners then remove
the Belt Unit.
Scanner -
Error
Self- Will Automatically
Diagnostic Restart within 15
minutes.
Short paper Open the Back
Cover and then
press Start
Size Error Specify the
2-sided correct paper
Press Stop Key.
Specify the
correct paper and
load the same size
paper as the Printer
driver setting.
Size Reload correct
Mismatch paper in Tray1,
then press Start.
Reload correct
paper.
Small paper Open the Back
Cover and then
press Start
Lower line
Dot counter of the toner
cartridge or develop roller counter
has reached the upper limit was
detected.
After the waste toner sensor
detected that the waste toner box
was almost full, pages more than
the specified number have been
printed.
Some error was detected while
function code 55 was being
executed.
After the error was detected at the
fuser unit, power was turned ON
again and the error is being
checked.
The registration rear sensor
detected that the paper loaded in
the paper tray was smaller than the
specified size.
The registration rear sensor
detected that the fed paper was
larger or smaller than the
specified size in 2-sided printing.
For 2-sided printing, the tray whose
paper size was not supported by
2-sided printing was selected.
The size of paper loaded in the
paper tray and the one specified
from the driver are not same when
paper is fed from the paper tray.
Some paper size error occurred
while fax, list, or report was being
printed.
When printing with the back cover
closed, the paper size selected in
the print data is smaller than the
valid size.
2-28
Description
Error Refer
codes to:
4C01 2-46
4C02
4C03
4C04
4C05
4800 2-44
B700 2-75
B800
B900
BB00
BD00
6902 2-54
8D01 2-63
8A01 2-62
9701 2-66
9002 2-64
8E01 2-63
8E02 2-64
8E03
8D02 2-63
Confidential