Advertisement
Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
Knob/lever keeper
Insert screwdriver
blade here.
Figure-8
core hole
Figure 10 Removing the outside knob/lever
"
2 1/4
groove
"
2
"
1 3/4
Outside
rose liner
Figure 11 Adjusting the rose liner for the door thickness
10
Through-
bolt stud
Hub face
Rose locking
pin
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc
Installing the lock & through-bolt trim
10
Remove outside knob/lever
1 Insert the control key into the core and rotate the key
15 degrees to the right.
2 Insert a flat blade screwdriver into the figure-8 core
hole and into the knob/lever.
3 Press the screwdriver blade in the direction of the
arrow in Figure 10.
Note: You cannot remove the knob/lever if the
screwdriver blade is inserted too far past the keeper.
4 Slide the knob/lever off of the sleeve.
Caution: Be careful that you do not disconnect the lever
keeper spring.
11
Adjust for door thickness
1 Determine the door's thickness.
2 Pull the rose locking pin and rotate the outside rose
liner until the proper groove on the through-bolt stud
lines up with the hub face.
Note 1: Make sure that the locking pin fully locks into
the rose liner.
Note 2: The lockset fits doors 1 3/4" to 2 1/4" thick.
(A spacer is available for 1 3/8" doors.)
Advertisement
