Advertisement
Installing the lock & through-bolt trim
20
Install inside and outside knobs/levers
Note: To use a core and throw member from a
manufacturer other than Stanley® with a 9KW Lock,
see the Installation Instructions for 9K Non-
interchangeable Cores & Throw Members (T56093).
Skip task 17 and task 18.
1 For the inside and outside knobs
Push firmly on the knob until it is seated.
For the inside and outside levers
With the handle pointing toward the door hinges,
push firmly on the lever until it is seated.
2 Turn the knobs/levers to check that they operate
smoothly.
21
Install core and throw member
1 Install the blocking plate onto the throw member.
Caution: You must use the blocking plate to prevent
unauthorized access.
For 6-pin core users only: Install the plastic spacer
(not shown, supplied with permanent cores) instead of
the blocking plate, on the throw member.
2 Insert the control key into the core and rotate the key
15 degrees to the right.
3 Insert the throw member into the core.
4 Insert the core and throw member into the knob/lever
with the control key.
5 Rotate the control key 15 degrees to the left and
withdraw the key.
Caution: The control key can be used to remove cores
and to access doors. Provide adequate security for the
control key.
Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
Figure 19 Installing the knobs/levers
Figure 20a Installing the blocking plate and throw
Throw
member
Core
Control
key
Figure 20b Installing the core
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc
Outside of door
member
Core
Blocking
plate
Throw
member
17
Advertisement
