Advertisement
Preparing the door and door jamb
5
Install latch
1 Install the latch in the door.
Note: The latch tube prongs should be centered and
should project into the chassis hole.
2 Check that the door swings freely.
6
Use drill jig to drill through-bolt holes
(9KW only)
1 Press the drill jig (KD303) onto the door, engaging it
with the latch tube prongs. Make sure the front edge
of the jig is parallel with the door edge.
2 Drill the through-bolt holes (5/16" diameter) halfway
into the door.
3 Turn the drill jig over and repeat steps 1 and 2 from the
opposite side of the door.
Note: Replace the drill jig after 10 door preparations.
Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
Figure 5 Installing the latch in the door
Figure 6 Installing the drill jig and drilling the
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc
Latch tube prong
Latch
Chassis hole
Inside of door
through-bolt holes
Inside of door
Drill upper through-
bolt hole.
Latch tube prongs
Drill lower through-
bolt hole.
7
Advertisement
