Advertisement
Preparing the door and door jamb
2
Drill holes and mortise for latch face
1 Drill the holes listed below:
upper and lower trim holes
■
—5/8" diameter
—through door
door status switch & LH/LHRB reader wire hole
■
—7/8" diameter
—through door
field harness & RH/RHRB reader wire hole
■
—7/8" diameter
—through door
■
door status switch hole
—1" diameter
—meets door status switch & LH/LHRB reader wire
hole
solenoid wire hole
■
—3/8" diameter
—through door
—before drilling chassis hole
chassis hole
■
—2 1/8" diameter
—through door
—after drilling solenoid wire hole
latch hole
■
—1" diameter
—meets chassis hole
Note 1: To locate the center of a hole on the opposite
side of the door, drill a pilot hole completely through
the door.
Note 2: For holes through the door, it is best to drill
halfway from each side of the door to prevent the door
from splintering.
2 Mortise the edge of the door to fit the latch face.
Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
Upper trim
hole
Door status
switch hole
Latch hole
Latch face
mortise
Figure 2 Drilling holes and mortising for the latch face
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc
Field harness &
RH/RHRB
reader wire
hole
Door status
switch & LH/
LHRB reader
wire hole
Solenoid wire
hole
Chassis hole
Lower trim
hole
Inside of door
5
Advertisement
