Advertisement
Installing the lock & through-bolt trim
17
Complete connections
Caution: When routing the solenoid and sensor wire
harness, the sensor wires, and the solenoid wires, make
sure the wires are not routed across any sharp edges or
over any surface that could damage their sleeving or
wire insulation.
1 Make the three (3) sensor connections and solenoid
connection, and place the wires onto the fire plate.
Wire connection
Solenoid
RQE
Shorting connection
Door status sensor
Caution: When making the sensor connections and
solenoid connection, make sure:
there are no loose wire connections where the
■
wires are inserted into the connectors
the connectors are firmly mated.
■
18
Install bottom cover
(inside escutcheon)
1 Making sure that the cover does not pinch the
wires, guide the bottom cover over the chassis onto
the fire plate.
2 Use two cover screws to secure the cover to the side of
the fire plate, as shown in Figure 17.
Note: Phillips Type 2 and T20 Torx options are available
for the cover mounting screws.
Caution: Dress all wires away from possible pinch points
before bottom cover is put in place.
Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
No. of
No. of
Color
wires
pins
Yellow
2
3
Brn/Org
2
3
Purple
2
2
White
2
2
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc
Inside of door
Figure 17 Installing the bottom cover
Bottom
cover
Cover
screws
15
Advertisement
