Table of Contents
Advertisement
3.2
Installing the Solenoid Lock Assembly
3.2.1
Refer to Figure 2, and PERFORM the following:
•
•
3.2.2
INSTALL, but do not tighten, the fasteners securing the lock assembly to the header.
If the latch does not retract into the position shown in Figure 1, the cam may have been manually rotated
and its motion restricted by the switch rollers S2 and S3. Using a small screwdriver or similar tool,
carefully press the two switch rollers to release the cam.
3.2.3
Manually RELEASE (UNLOCK) the pawl such that the latch retracts into the lock
assembly housing.
3.2.4
Manually SLIDE the door(s) to the fully closed position.
3.2.5
Refer to Figure 3, and MOVE the lock assembly to the position shown.
(UNLOCKED)
© 2009, THE STANLEY WORKS. ALL RIGHTS RESERVED.
POSITION the lock assembly in the header at the position shown.
ENSURE the lock assembly is aligned with the track tube mark from step 3.1.5.
NOTE
Figure 3. Installing the Solenoid Lock
PAWL
DOOR CLOSED AND UNLOCKED
PAWL
(LOCKED)
DOOR CLOSED AND LOCKED
LATCH
CAM
GREASE
HERE
BELT BRACKET
1/8"
(DOOR CLOSED)
LATCH
CAM
GREASE
HERE
BELT BRACKET
1/8"
(DOOR CLOSED)
203820
Rev. G, 3/14/09
5 of 15
LOCK
HOUSING
LOCK
HOUSING
SL003
Advertisement
Table of Contents
