Advertisement
Preparing the door and door jamb
8
Install door status switch and magnet
1 On the door jamb, mark the drill point for the
1" diameter magnet hole. This hole should be directly
opposite the door status switch reader wire hole when
the door is closed.
2 Drill a 1" diameter hole for the magnet, at least
1 3/4" deep.
3 Insert the magnet in the hole.
4 Insert the door status switch assembly into the door
status switch hole in the edge of the door, feeding the
connectors out the wire hole to the inside of the door,
as shown in Figure 8.
9
Install strike box and strike plate
1 In alignment with the center of the latchbolt, mortise
the door jamb to fit the strike box and strike plate.
2 Insert the strike box and secure the strike with the two
screws provided.
3 Check the position of the deadlocking plunger against
the strike plate.
Caution: The deadlocking plunger of the latchbolt must
make contact with the strike plate, as shown in Figure
9b. The plunger deadlocks the latchbolt and prevents
someone from forcing the latch open when the door is
closed.
Deadlocking
plunger
Strike plate
Figure 9b Aligning the deadlocking plunger with the
strike plate
Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
Figure 8 Installing the door status switch and magnet
Figure 9a Installing the strike box and strike plate
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc
Wire hole
Magnet
Door
status
switch
Door jamb
Door jamb
Inside of door
Strike box
Strike plate
9
Advertisement
