Advertisement
Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
Reader wire harness
connector
Outside trim
Figure 16a Feeding the reader wire harness connector
through the wire hole
Figure 16b Connecting the reader wire harness to the
control electronics circuit board and
mounting the fire plate
14
Outside of door
Control
electronics
circuit board
Reader wire
harness
connector
Mounting
screw
Solenoid
wire
Mounting
screw
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc
Installing the lock & through-bolt trim
16
Connect reader wire harness
1 For LH and LHRB doors
From the outside of the door, feed the reader wire
harness connector through the door status switch &
LH/LHRB reader wire hole.
For RH and RHRB doors
From the outside of the door, feed the reader wire
harness connector through the field harness &
RH/RHRB reader wire hole.
Caution: When routing the reader wire harness, make
sure the reader wire harness is not routed across any
sharp edges or over any surface that could damage its
sleeving or wire insulation.
2 On the inside of the door insert the two countersunk
mounting screws into the holes at the top and bottom
of the fire plate.
3 Tighten the mounting screw to the outside
escutcheon until the fire plate and escutcheon are
securely mounted to the door.
4 Connect the reader wire harness to the control
electronics circuit board in the inside trim.
Caution: When connecting the reader wire harness,
make sure:
there are no loose wire connections where the
■
wires are inserted into the reader wire connector
the reader wire harness connector is fully
■
seated in its mating connector on the control
electronics circuit board.
Advertisement
