Setting The Screen Calibration - Leica mojo 3D User Manual

Leica mojo3D, Running the mojo3D for the First Time
3.2
General informa-
tion
Setting the screen
size, step-by-step


Setting the Screen Calibration

Differences may exist between different devices, and so the screen calibration must
be set before operation.
1. Tap - with your finger, not an object - the middle of the screen calibration
icon, which is in the top left-hand corner of the screen. The icon will appear in
another position. Continue to tap the middle of each icon until the corners and
centre of the screen are defined. You will need to tap the screen five times.
2. The Initial Setup Wizard appears on the screen. Tap
screen to continue with the initial setup.
If required, Screen Calibration can be updated anytime while the mojo3D is powered
on by holding the power button for 8 seconds, release the power button to display
the screen calibration screen. If the power button is held for more than 15 seconds
the mojo3D will turn off.
at the bottom of the
34