System Installation; Before Installation - Leica mojo 3D User Manual

Leica mojo3D, System Installation
2
2.1
General installa-
tion information

System Installation

Before Installation


The installer must read and study this user manual, including the safety
directions. The installer must be able to use the system in accordance with
the user manual. Leica Geosystems recommends that installation of the
mojo3D equipment be performed by a qualified technician, because instal-
lation requires making electrical connections.
• The following instructions are to be used as a general guide during the installa-
tion of the mojo3D.
• The system will not operate at peak performance if steering joints and linkage
assemblies are not within the manufacturer's specifications. Check for worn
steering components by turning the steering wheel. As the steering wheel is
turned, the wheels should begin to move. If results are undesirable, please
consult your vehicle manufacturers' maintenance manual.
• Install the system in a clean and dry workshop environment. Failure to do so may
cause the system to short or promote product malfunction. Any moisture on
the roof of the vehicle will also prevent the antenna mounting tape from
sticking properly.
• Route and secure all cables and wiring to ensure that they do not chafe or rub,
causing premature failure.
20