Removing Seat Pad For Cleaning - DJG Vantage Point Surveyor Instruction Manual

4358-3492D Singles 5/27/09 2:19 PM
4
6
5
4
3
1
2
5
WARNING
!
Failure to reattach the buckle and harness
correctly, can result in serious injury or
death.
38
Page 41
Thread one end of
harness down through slot
on left side of shell (1),
across bottom of shell (2)
and up through slot on
right side (3). Be sure
harness adjustment strap
is between shell and
harness strap.
Thread one buckle plate
onto harness from back to
front (4).Thread the
harness retainer (5). Do
the same to the other
harness end. Make sure
the harness is not twisted.
Push harness ends through
upper slots in shell (6).
Fit loops on harness ends
onto the splitter plate.

Removing Seat Pad for Cleaning

WARNING
!
Do not use this child restraint without the
seat pad. Failure to do this can result in
serious injury.
Remove harness as
1
described in the "Belt-
Positioning Booster"
section.
Pull arm covers off arms
and pull through hole in
back of shell.
From back of shell, release
2
the elastic straps and the 6
harness guides shown in
red.
Remove harness guides by
3
pushing down on one edge
with one hand and pulling
out from the front side
with the other.
39
continued on next page.