Latch - DJG Vantage Point Surveyor Instruction Manual

4358-3492D Singles 5/27/09 2:19 PM
4
WARNING
!
Using this child restraint in any vehicle seat
where the lap belt cannot be tightened
securely and properly or where it can be
loosened by pulling on it can result in
serious injury or death.
5
26
Page 29
With weakest hand at belt
path, tilt and push the
child restraint forward and
back, and from side to
side. If the seat belts do
not loosen, your child
restraint should be secure.
NOTE: Some "play" from
front to back or about an
inch from side to side is
acceptable. If it moves
more, review "Knowing
Your Vehicle Belts" and
"The Locking Clip"
sections.
After checking for hot
seat and buckles, place
your child in the child
restraint as described in
the "Securing Your Child in
the Child Restraint"
section.
Forward-Facing Installation with
LATCH Belt: Install LATCH Belts
NOTE:
1
LATCH system along
with the adult lap or
lap/shoulder belt.
Route LATCH belt
through upper slot in
side of shell.
Pull one LATCH hook
2
across the back and out
the other side.
The LATCH adjuster
can be on either side,
but the belt should not
be twisted.
Connect and tighten
3
harness straps prior to
installing in vehicle.
Place child restraint flush
against the back of the
vehicle seat forward-
facing in the back seat.
The recline position is to
be used only to install the
child restraint flush
against the back of the
vehicle seat back, if
needed.
27
Do not use
continued on next page.