Table of Contents
Advertisement
4358-3492D Singles
5/27/09
2:19 PM
4
5
6
28
Page 31
Fasten one LATCH belt
hook to the anchor in the
vehicle seat located in the
vehicle seat bight. Repeat
for other side of child
restraint. See your vehicle
owner's manual for
locations and more
information.
Place one knee in the child
restraint and push down
firmly while pulling up on
the loop to tighten belt.
With knee still in child
restraint, attach hook to
anchor in vehicle. Push
down firmly and tighten top
anchorage strap.
To adjust top anchorage
strap: See "Adjusting Top
Anchorage Strap" section.
With weakest hand at
7
belt path, tilt and push
the child restraint
forward and back, and
from side to side. If the
LATCH belts do not
loosen, your child
restraint should be
secure.
NOTE:
front to back or about an
inch from side to side is acceptable.
If the child restraint does not remain tight, do not use
the child restraint in this seating location with this
LATCH system.
WARNING
!
LATCH hooks MUST be securely
fastened. Failure to do this can result in
serious injury or death.
After checking for hot
8
seat and buckles, place
your child in the child
restraint as described in
the "Securing Your Child
in the Child Restraint"
section.
To release LATCH:
Remove child from child
restraint. Press down
firmly on adjuster side
of child restraint and
press release button to
release tension.
Unhook LATCH from
bar by squeezing spring
lever and twist hook.
29
Some "play" from
Advertisement
Table of Contents
