Table of Contents
Advertisement
4358-3492D Singles
5/27/09
2:19 PM
Forward-Facing Installation
After deciding whether to use your Vehicle Belts or
LATCH, be sure to read the warnings below as they
pertain to both systems.
WARNING:
!
Loose LATCH hooks can result in serious
injury or death.
24
Page 27
When LATCH is not being
used, fasten belt hooks
together behind the child
restraint as shown.
Forward-Facing Installation with
Vehicle Belts:
Connect and tighten
1
harness straps prior to
installing in vehicle.
Place child restraint flush
against the back of the
vehicle seat forward-
facing in the back seat.
The recline position is to
be used only to install the
child restraint flush against
the back of the vehicle seat back, if needed.
Thread the vehicle lap belt or lap/shoulder belt
combination through the belt path and out other side.
Buckle.
Place one knee in the
2
child restraint and push
down firmly while pulling
up on belt to tighten. For
a manual belt, refer to
"Knowing your Vehicle
Belt" section.
With knee still in child
3
restraint, attach hook to
anchor in vehicle. Push
down firmly and tighten
top anchorage strap.
To adjust top anchorage strap: See "Adjusting Top
Anchorage Strap" section.
NOTE:
If your vehicle does not have an anchor
bracket, tuck the top anchorage strap's hook under
the child restraint.
25
continued on next page.
Advertisement
Table of Contents
