Connecting Power (If Required); Synapse Interface - Motorola Symbol LS9208 Product Reference Manual

Symbol LS9208 Product Reference Guide

Connecting Power (if required)

If your host does not provide power to the scanner, you will need an external power
connection to the scanner:
1. Connect the interface cable to the back of the scanner, as described in
the Interface Cable
2. Connect the other end of the interface cable to the host (refer to your host manual
to locate the correct port).
3. Plug the power supply into the power jack on the interface cable.
4. Plug the other end of the power supply into an AC outlet.

Synapse Interface

The auto-detection of a Synapse cable varies in duration depending on the type of Synapse
connection. If a scanner is connected to a host using a Synapse cable then the Auxiliary
Synapse Port connection should be used. In all other cases, where a Synapse cable is used
the default setting is recommended.
Should the user want to disconnect and reconnect the scanner from a Synapse cable that
is connected to a live host, then the "Plug and Play" setting should be used. This setting
should not be changed from the default if an on-board wedge host is enabled.
1-4
on page 1-3.
* Standard Synapse Connection
Installing