Selecting Beeper Volume Using Trigger - Motorola Symbol LS9208 Product Reference Manual

Symbol LS9208 Product Reference Guide
Beeper Sequence
Lo/hi/lo beep
Lo/hi beep
Host Specific
USB only
4 short high beeps
Scanner gives a power-up
beep after scanning a USB
Device Type.
This power-up beep occurs
more than once.
RS-232 only
1 short high beep

Selecting Beeper Volume using Trigger

The scanner emits a short beep when it successfully reads a bar code. The volume of the
beep can be changed either by scanning the appropriate bar code in
page 4-7, or by utilizing the trigger as follows:
1. Press and hold the trigger for an extended period of time (approximately 5
seconds). The scanner cycles through three settings (Low, Medium, High) emitting
a 2-beep tone at each setting.
2. To select a particular setting, release the trigger after the desired 2-beep tone is
heard.
2-8
Table 2-1. Standard Beeper Definitions (Continued)
The Code 39 buffer was erased or there was an
attempt to clear or transmit an empty buffer.
A successful transmission of buffered data.
Scanner has not completed initialization. Wait
several seconds and scan again.
Communication with the bus must be established
before the scanner can operate at the highest
power level.
The USB bus may put the scanner in a state where
power to the scanner is cycled on and off more than
once. This is normal and usually happens when the
PC cold boots.
A <BEL> character is received and Beep on <BEL>
is enabled.
Indication
Beeper Volume on