Connecting An Rs-232 Interface; Rs-232 Default Parameters - Motorola Symbol LS9208 Product Reference Manual

Connecting an RS-232 Interface

This connection is made directly from the scanner to the host computer.
1. Connect the RS-232 interface cable to the rear of the scanner, as described in
Installing the Interface Cable
2. Connect the other end of the interface cable to the serial port on the host.
3. Connect the power supply.
4. Scan appropriate bar codes in this chapter to match your host settings.

RS-232 Default Parameters

Table 6-1 lists the defaults for RS-232 host parameters. If you wish to change any option,
scan the appropriate bar code(s) provided in the Parameter Descriptions section beginning
on page 6-5.
Power supply
Figure 6-1. RS-232 Direct Connection
on page 1-3.
Serial Port Connector to Host
Interface cable
RS-232 Interface
Power supply cable
Interface cable
6-3