Connecting A Synapse Cable Interface; Configuring Your Scanner - Motorola Symbol LS9208 Product Reference Manual

Symbol LS9208 Product Reference Guide

Connecting a Synapse Cable Interface

Note: See the Synapse Interface Guide provided with your Synapse cable
for detailed setup instructions.
Symbol's Synapse Smart Cables enable interfacing to a variety of hosts. The appropriate
Synapse cable has the built-in intelligence to detect the host to which it is connected.
To host
Synapse Smart Cable
1. Plug the Synapse adapter cable (p/n
as described in
2. Align the 'S' on the Synapse adapter cable with the 'S' on the Synapse Smart Cable
and plug the cable in.
3. Connect the other end of the Synapse Smart Cable to the host.

Configuring Your Scanner

Two methods are available to configure your scanner: using the bar codes included in this
manual, or the 123Scan configuration program.
Refer to Chapter 4, User Preferences
using bar code menus. Refer to
configuration program. A help file is available in the program.
The scanner supports RS-232, IBM 468X/469X, Keyboard Wedge, Wand Emulation, USB,
and Synapse to interface to a host system. Each host specific chapter describes how to set
up each of these connections.
1-6
Figure 1-3. Synapse Cable Connection
Installing the Interface Cable
for information about programming your scanner
Chapter 10, 123Scan
into the bottom of the scanner,
25-32463-xx)
on page 1-3.
to configure your scanner using this
Synapse adapter cable
To scanner