Timeout Between Decodes - Motorola Symbol LS9208 Product Reference Manual

Timeout Between Decodes

Timeout Between Decodes, Same Symbol
This parameter sets the minimum time between decodes of different symbols. It is
programmable in 0.1-second increments from 0.0 to 9.9 seconds. Setting this above 0.4
seconds is recommended.) The default for this parameter is 0.6 seconds.
Scan the bar code below to select a new timeout. Next, scan two numeric bar codes
beginning in Numeric Bar Codes
Single digit numbers must have a leading zero. For example, to set a timeout of 0.5
seconds, scan the bar code below, then scan the "0" and "5" bar codes. If you make an
error, or wish to change your selection, scan
Timeout Between Decodes, Different Symbol
This parameter sets the minimum time between decodes of different symbols. It is
programmable in 0.1-second increments from 0.0 to 9.9 seconds. The default for this
parameter is 0.2 seconds.
Scan the bar code below to select a new timeout. Next, scan two numeric bar codes
beginning in Numeric Bar Codes
Single digit numbers must have a leading zero. For example, to set a timeout of 0.5
seconds, scan the bar code below, then scan the "0" and "5" bar codes. If you make an
error, or wish to change your selection, scan
on page D-1 that correspond to the desired timeout.
Cancel
Timeout Between Same Symbol
on page D-1 that correspond to the desired timeout.
Cancel
Timeout Between Different Symbol
on page D-5.
on page D-5.
User Preferences
4-15