Sym Joyride 125 Service Manual page 176

To this chapter contents
11. AC. Generator / Start Clutch
Start Clutch Inspection
Check the starting clutch gear for wear or
damage.
Measure the ID and OD of the starting clutch
gear.
Service Limit:
ID: 20.1 mm
OD: 42.10 mm
Check the starting reduction gear and shaft for
wear or damage.
Install one way clutch onto starting clutch gear.
Hold flywheel and rotate starting clutch gear.
The starting clutch gear should be rotated in
C.C.W direction freely, but not C.W direction.
(View as shown in this figure.)
Disassembly
Remove 3 hexagon bolts with air and hex socket
wrenches.
11-5