To this chapter contents
13. Cooling System
Install the right crankcase cover.(bolt × 9)
Install the dowel pin and new gasket.
Install the water pump cover with three bolts.
Temperature sensor
Please refer to chapter 17 for inspection of
temperature sensor.
Removal
Remove the body cover.
Drain out the coolant.
Disconnect the cable of temperature sensor.
Remove the temperature sensor.
Installation
Apply a coat of 3 Bond No. 1212 sealant or
equivalent to the thread of temperature sensor
and install it on the holder.
Connect the cable to the temperature sensor.
Refill the coolant and bleed out the air bubble
(P12-4).
Install the right rear cover.
13-10