Install movable drive face comp. onto crankshaft.
Driven pulley installation
Press driving belt into pulley groove, and then
pull the belt onto drive shaft.
Install driven pulley, washer and nut.
Caution
Make sure that two sides of pulley surfaces
have to be free of grease. Clean it with
cleaning solvent.
Hold crankshaft with universal holder.
Tighten nut to specified torque.
Torque value: 5.0-6.0 kgf-m
Install left crankcase cover.
To this chapter contents
Movable drive face
Crankshaft
Universal holder
Drive face
9. V-Belt Drive System
Press down
Driving belt
Drive face
boss
Nut
9-9